HP Netserver E Server series - Manual (Page 12)

Chapter 1 Installation Overview
6
Install Additional Mass Storage Devices
If you are installing an IDE drive or internal SCSI devices in certain
configurations, you may need additional cables or adapters. For part numbers for
HP cables, adapters, and trays, and configuration information, see Information
Assistant on the Navigator CD-ROM. For new products, you can use Order
Assistant on the HP web site at this URL:
www.hp.com/go/netserver
Configure the HP NetServer
1. Reassemble the HP NetServer and connect the power cord.
2. If you have installed ISA non-Plug-and-Play adapter boards, you must
now allocate memory resources to each of these boards. Refer to the
"Installing ISA Non-Plug-and-Play Boards" in Chapter 4, "Accessories"
for instructions.
3. Turn on the HP NetServer and monitor.
4. Insert the CD-ROM into the CD-ROM drive now, turn off power to the
NetServer, wait 10 seconds, and turn it back on. The NetServer will boot
from the Navigator CD-ROM.
If the NetServer fails to boot, follow the directions displayed on the
screen.
5. Go to the Navigator Main Menu and select “Configuration Assistant."
Follow the instructions in Configuration Assistant to continue your NetServer
installation.