HP Mini 1103 - Manual (Page 54)

Password Function
NOTE: The administrator password can be used in place of
the power-on password.
NOTE: A power-on password is not displayed as it is set,
entered, changed, or deleted.
*For details about each of these passwords, refer to the following topics.
Managing an administrator password
To set, change, or delete this password, follow these steps:
1. Open Setup Utility by turning on or restarting the computer. While the “Press the ESC key for
Startup Menu” message is displayed in the lower-left corner of the screen, press
esc . When the
Startup Menu is displayed, press f10 .
2. Use the arrow keys to select Security > Set Administrator Password, and then press enter .
● To set an administrator password, type your password in the Enter New Password and
Confirm New Password fields, and then press
enter .
● To change an administrator password, type your current password in the Enter Current
Password field, type a new password in the Enter New Password and Confirm New
Password fields, and then press
enter .
● To delete an administrator password, type your current password in the Enter Password field,
and then press
enter 4 times.
3. To save your changes and exit Setup Utility, use the arrow keys to select Exit > Exit Saving
Changes.
Your changes take effect when the computer restarts.
Entering an administrator password
At the Enter Password prompt, type your administrator password, and then press enter . After 3
unsuccessful attempts to enter the administrator password, you must restart the computer and try again.
46 Chapter 6 Security