A&D Digital Scale SK-1000WP - Manual (Page 4)

- 3 -
PREPARATION
Installing Batteries / Connecting the AC Adapter
Installing Batteries
CAUTION When replacing batteries, be careful
not to apply too much force to the
weighing platform. An excessive
force could damage the scale.
Unlock and remove the battery cover.
(See illustration at the right)
Insert six new batteries (R20P / LR20 / D
size) into the battery compartment, taking
extreme care to that the plus and minus
polarities are observed.
Be sure to install and lock the battery
cover after installing the batteries.
AC Adapter (Optional)
CAUTION When using an AC adapter, the
scale doesn’t comply with IP65.
The AC input requirement
could be 100, 120, 220, 230
or 240 volts (50/60Hz)
depending on the area where
used, so please verify that the
adapter is the correct type.
Plug the AC adapter to the AC adapter
socket inside the battery compartment.
Setting up the Scale
CAUTION Avoid installing the scale in direct sunlight, that may cause
discoloration or malfunctions. Place your SK-WP on a firm
weighing table so that the scale is level. The scale will not perform
accurately when it is not level.
Place the scale on a firm surface and adjust the feet to level the scale,
while using the sprit level, for accurate weighing.
New six batteries. (R20P/ LR20/ D size)