Avenview SW-VGA-5X5 - Manual (Page 10)

www.avenview.com 10
In the GUI String Table group, click on “Rename” button and assign the captions for each input and
output port for easy recognition.
For example
Rename the Input1 to “Main PC”, Input2 to “Sub PC,” input3 to “PC-3,” … etc., and rename
output1 to “Conf. RM1,” output2 to “Main monitor,” output3 to “Lobby,” output4 to “Main
projector,” … etc.
2. Scan Button:
Serial Port Scan
Click Scan button, the machine will scan the all com
port and show them.
Select the RS232 serial port connected to the
machine. And set device ID 255 is for all device.
Only the same device id or 255 can get the
command you sent.
Click OK. Get the new status from the machine you
select.
3. Linkage Button:
Click Linkage button to read back all status.