HP PCIe IO Accelerators for ProLiant Servers User Manual
Page 35
Linux environments 35
NOTE:
For proper operation, the subagent file name must be fio-snmp-agentx.conf.
When the SNMP Agentx runs, it reads the fio-snmp-agentx config file:
###################################################################
# Example config file for fio-snmp-agentx SNMP AgentX subagent.
#
# Hewlett Packard #
agentxsocket tcp:localhost:705
# test_mode_enabled
# set to 1, true or yes to enable 0, false or no to disable (default: false)
test_mode_enabled true
# traps_enabled
traps_enabled true
# testmode_file
# name of test mode file (default: testmode.ini)
testmode_file testmode.ini
# update_delay
# delay between agent polling requests in milliseconds (default: 250)
update_delay 100
# mib_select
# select the CPQIODRV-MIB
mib_select cpq
###################################################################
The following are conditions for test mode:
•
If the Admin has set the test_mode_enabled parameter from TRUE to FALSE, the SNMP Agentx
does not try to run test mode. Instead, it continues processing data as usual from the IO Accelerator
driver, storing the data in the MIB.
•
If the CONF file says that test_mode_enabled is TRUE, the SNMP Agentx reads the
testmode_file line to locate the testmode.ini file.
•
If the testmode.ini file shows the test mode is set to ON, then it engages the test mode.
•
If test mode is ON, the SNMP Agentx reads the next line, TestModeIndex, to identify which IO
Accelerator to test. The number in this parameter is the device number shown using fio-status
such as:
PCI:01:00.0
The first two numerals identify the bus number (in this example, 01).