GE GTDN550GDWW - Manual (Page 7)

Installation Instructions
7
 '5<(5(;+$867725,*+7/()725
BOTTOM CABINET
:$51,1* BEFORE PERFORMING
7+,6(;+$867,167$//$7,21%(685(
TO DISCONNECT THE DRYER FROM ITS
(/(&75,&$/ 6833/< 3527(&7 <285
HANDS AND ARMS FROM SHARP
EDGES WHEN WORKING INSIDE THE
&$%,1(7%(685(72:($5*/29(6
Note: Only 4” round rigid metal ducting allowed inside
dryer.
TAB LOCATION
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
REMOVE
SCREW
AND SAVE.
REMOVE
DESIRED
KNOCKOUT
(ONE ONLY).
ADDING NEW DUCT
ADDING ELBOW AND DUCT FOR
(;+$86772/()76,'(2)&$%,1(7
• Preassemble 4” elbow with 4” duct. Wrap duct tape
around joint.
‡,QVHUWGXFWDVVHPEO\HOERZ¿UVWWKURXJKWKHVLGH
opening and connect the elbow to the dryer internal
duct.
CAUTION:
%HVXUHQRWWRSXOORUGDPDJH
WKHHOHFWULFDOZLUHVLQVLGHWKHGU\HUZKHQLQVHUWLQJWKH
GXFW
• Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
Cut the duct as shown and keep portion A.
9"
A B
FIXING HOLE
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45º using a flat
blade screwdriver.
BEND TAB
UP 45
o
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
LEFT SIDE
EXHAUST
PORTION "A"
FIXING
HOLE
EXHAUST CAN
BE ADDED TO
LEFT OR RIGHT SIDE
DUCT
TAPE
DUCT
TAPE CAUTION:
Internal duct joints must be
VHFXUHG ZLWK WDSH RWKHUZLVH
they may separate and cause
DVDIHW\KD]DUG
GARAGE INSTALLATION (IF ALLOWED
%</2&$/&2'(6
• Dryers installed in garages must be elevated 18 inches
FP DERYHWKHÀRRU