GE PSB9120DFBB - Manual (Page 5)

Installation Preparation
5
ELECTRICAL REQUIREMENTS
Single Advantium 120 Installation:
This product requires a 120-volt, 60 Hz, 15-amp
circuit and draws 1.8 kilowatts. This product must be
connected to a supply circuit of the proper voltage
and frequency.
‡:LUHVL]HPXVWFRQIRUPWRWKHUHTXLUHPHQWVRIWKH
National Electrical Code or the prevailing local code
for this kilowatt rating.
‡7KHSRZHUVXSSO\FRUGDQGSOXJVKRXOGEHEURXJKW
to a separate 15 or 20 ampere branch circuit single
grounded receptacle. The outlet box should be
located within reach of the 48” power cord.
ELECTRICAL LOCATION
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the
risk of electric shock by providing an escape wire
for electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded.
WARNING: Improper use of the grounding
plug can result in a risk of electric shock.
¡ADVERTENCIA!: El uso inadecuado del
enchufe de conexión a tierra puede provocar un
riesgo de descarga eléctrica.
Important: (Please read carefully).
The power cord of this appliance is equipped with
a three-prong (grounding) plug that mates with a
standard three-prong grounding wall receptacle to
minimize the possibility of electric shock. Consult a
qualified electrician or serviceman if the grounding
instructions are not completely understood, or if
doubt exists as to whether the appliance is properly
grounded.
‡:KHUHDVWDQGDUGWZRSURQJZDOOUHFHSWDFOHLV
encountered, it is the personal responsibility and
obligation of the consumer to have it replaced with a
properly grounded three-prong wall receptacle.
Do not, under any circumstances, cut or remove the
third (ground) prong from the power cord.
DO NOT USE AN EXTENSION CORD. If the power
supply cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
Install a recessed electrical outlet in the back wall
of the opening within 6s of either side and at least
9s above the cutout floor.
Locate outlet box in the shaded area
6”
9”