GE GML04GAEBS - Manual (Page 7)

7
Turn counterclockwise to
raise, clockwise to lower.
/(9(/,1*/(*6
$GMXVWDEOHOHJVat the front corners of the refrigerator
should be set so the refrigerator is firmly positioned
on the floor, and the front is raised just enough that
the door closes easily when opened about halfway.
To adjust the leveling legs, turn the legs counterclockwise to
raise the refrigerator, clockwise to lower it.
If you have questions, call 1.800.GE.CARES
RU visit our Website at:
GEAppliances.com
,QVWDOODWLRQ
Refrigerator




,QVWUXFWLRQV
 
%()25(<28%(*,1
5HDGWKHVHLQVWUXFWLRQVFRPSOHWHO\DQGFDUHIXOO\
• 
,03257$17²
 Save these instructions for local
inspector’s use.
•
,03257$17²
 Observe all governing codes
and ordinances.
• 1RWHWR,QVWDOOHU² Be sure to leave these instructions
with the Consumer.
• 1RWHWR&RQVXPHU² Keep these instructions
for future reference.
/2&$7,215(48,5(0(176
• Do not install the refrigerator where the temperature will go
below 50°F (10°C) because it will not run often enough to
maintain proper temperatures.
• Install it on a floor strong enough to support it fully loaded.
• Do not install it in a recessed area.
• Do not build in the refrigerator.
&/($5$1&(6
Allow the following clearances for ease of installation and
proper air circulation.
3 and 4
Cubic Foot Models
Sides 1/2” (13 mm)
Top
2” (51 mm)
Back 2” (51 mm)**
**From the rear cabinet surface to the wall
813$&.,1*<2855()5,*(5$725
• Remove tape and any labels (except for the rating label)
from your refrigerator. Tape or glue residue can also be
removed by rubbing a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm
water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your
refrigerator.
• When moving the refrigerator, do not tilt the refrigerator
beyond 45° from upright position.
3 Cubic Foot Models
4 Cubic Foot Models