GE PT925DNBB - Manual

1
Single Double Wall Oven Installation
Instructions
Before You Begin
Read these instructions carefully and completely.
•
IMPORTANT
—Save these
instructions for local inspector’s use.
•
IMPORTANT
—Observe all
governing codes and ordinances.
• Note to Installer—Be sure to leave these
instructions with the consumer.
• Note to Consumer—Keep these
instructions for future reference.
• Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
• NOTE—This appliance must be properly
grounded.
•
ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction box.
A plug and receptacle is NOT permitted on
these products.
Tools Needed
1/8” (3 mm) Drill Bit and
Electric or Hand Drill
Nut Driver 7/16”
(11 mm)
Materials Needed
Strain Relief Clamp for
1/2” conduit
Junction Box
Wire Nuts
String 72”
(183 cm)
31-10696 07-08 JR
Parts Included
(Appearance will vary)
Screws For Installation
(8-18 x .625 Black Dome
Phillips Head)
Lower Oven
Rack Supports
with Hex Nuts
PT925
30” (76.2 cm)
Metal Bottom Trim Assembly
Hex Nuts
If you have questions, call 1.800.GE.CARES or visit our website at: ge.com
Wire Strippers
Phillips #2
Screwdriver