Installing the beverage center/wine chiller – GE GVS04BDWSS User Manual

Page 4

Advertising
background image

Installing the beverage center/wine chiller.

4

Removing the Packaging

Before using the beverage center/wine chiller, be sure all packing materials and tape have

been removed, including the protective film covering the control and any film protecting

the cabinet.
If you are discarding an old refrigeration product, remove the doors to reduce the danger

of children being trapped inside.

To raise the appliance

„

The beverage center/wine chiller can be

freestanding or can be installed under the

counter, with proper clearances.

„

Allow the following clearances for ease

of installation, proper air circulation and

electrical connections:
Each side

1/2” (12,7 mm)

Top

2” (51 mm)

Back

2” (51 mm)

„

Before connecting the appliance to the

power source, let it stand upright for

approximately 2 hours. This will reduce

the possibility of a malfunction in the

cooling system from handling during

transportation.

„

Do not install the beverage center/wine

chiller where the temperature will go

below 55°F (12,7°C) or above 90°F (32,2°C).

If the room temperature is below the

temperature setting, the beverage center/

wine chiller will not operate (for instance, if

the room is at 55°F (12,7°C) and the setting

is 60°F (15,6°C), the unit will not run).

„

Install it on a level floor.

„

Do not install the beverage center/wine

chiller where it will be subject to direct

sunlight, heat or moisture.

„

Do not store or install this appliance

outdoors.

Installation Guidelines

Adjustable legs at the front corners of the

beverage center/wine chiller should be set

so the beverage center/wine chiller is firmly

positioned on the floor, with a 1/8” tilt to the

back to help the door closure.
To adjust the leveling legs, turn the legs

counterclockwise to raise the beverage

center/wine chiller, clockwise to lower it.

Leveling Legs

The door handle and screws are shipped in a

hardware bag attached to one of the shelves

inside the cabinet.
Locate the door handle and two screws.

Secure the door handle to the side of the door

as shown.

Door Handle

Screw

Door

Handle

Advertising