GE GTDL210EDWW - Manual

WARNING
RISK OF FIRE
• To reduce the risk of severe injury or death, follow all installation
instructions.
‡&ORWKHVGU\HULQVWDOODWLRQPXVWEHSHUIRUPHGE\DTXDOL¿HGLQVWDOOHU
• Install the clothes dryer according to these instructions and in
accordance with local codes.
• This dryer must be exhausted to the outdoors.
• Use only rigid metal 4” diameter ductwork inside the dryer cabinet and
use only UL approved transition ducting between the dryer and the home
duct.
‡'2127LQVWDOODFORWKHVGU\HUZLWKÀH[LEOHSODVWLFGXFWLQJPDWHULDOV
,I ÀH[LEOH PHWDO VHPLULJLG RU IRLOW\SH  GXFW LV LQVWDOOHG LW PXVW EH
UL listed and installed in accordance with the instructions found in
´&RQQHFWLQJ7KH'U\HU7R+RXVH9HQWµRQSDJHVRIWKLVPDQXDO
Flexible venting materials are known to collapse, be easily crushed,
DQGWUDSOLQW7KHVHFRQGLWLRQVZLOOREVWUXFWGU\HUDLUÀRZDQGLQFUHDVH
WKHULVNRI¿UH
• Do not install or store this appliance in any location where it could be
exposed to water and or weather.
‡6DYHWKHVHLQVWUXFWLRQV ,QVWDOOHUV %HVXUHWROHDYHWKHVHLQVWUXFWLRQV
ZLWKWKHFXVWRPHU 
NOTE: Installation and service of this dryer requires basic
mechanical and electrical skills. It is your responsibility to
FRQWDFWDTXDOL¿HGLQVWDOOHUWRPDNHWKHHOHFWULFDOFRQQHFWLRQV
Installation
Instructions Electric Dryer
02
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
•
IMPORTANT-
Save these instructions
for local inspector’s use.
•
IMPORTANT-
Observe all governing
codes and ordinances.
• Note to Installer -%HVXUHWROHDYHWKHVH
instructions with the customer.
• Note to Customer - Keep these instructions
with your Owner’s Manual for future
reference.
‡%HIRUHWKHROGGU\HULVUHPRYHGIURPVHUYLFH
or discarded, remove the dryer door.
• Service information and the wiring diagram
are located in the control console.
• Do not allow children on or in the appliance.
Close supervision of children is necessary
when the appliance is used near children.
• Install the dryer where the temperature is
DERYH ƒ) IRU VDWLVIDFWRU\ RSHUDWLRQ RI
the dryer control system.
• Product failure due to improper installation
is not covered under the Warranty.
TOOLS YOU
WILL NEED
PHILLIPS SCREWDRIVER
SLIP JOINT PLIERS
LEVEL
FLAT BLADE SCREWDRIVER
MATERIALS YOU WILL NEED
GLOVES
SAFETY
GLASSES
DRYER POWER
CORD KIT
(NOT PROVIDED
WITH DRYER)
4" DUCT
CLAMPS (2)
OR
4" SPRING
CLAMPS (2)
EXHAUST
HOOD
3/4" STRAIN
RELIEF
UL RECOGNIZED
4" DIA. METAL
ELBOW
4" DIA. FLEXIBLE METAL (SEMI-RIGID)
UL LISTED TRANSITION DUCT
(IF NEEDED)
KIT WX08X10077 (INCLUDES 2 ELBOWS)
4" DIA. METAL DUCT
(RECOMMENDED)
4" DIA. FLEXIBLE METAL (FOIL TYPE)
UL LISTED TRANSITION DUCT
(IF NEEDED.)
DUCT TAPE
UL RATED
120/240V,30A
WITH 3 OR 4 PRONGS.
IDENTIFY THE PLUG
TYPE AS PER THE
HOUSE RECEPTACLE
BEFORE PURCHASING
LINE CORD.
4” COVER PLATE (IF NEEDED
(KIT WE1M454)
Questions? Call 800.GE.CARES (800.432.2737) or visit our Web site at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
31-16751
 GE
234D2216P002