GE ZSC2201NSS - Manual (Page 2)

monogram.com
21
Abov
e-the-cook
top
A
dv
antium
Speedcook
ov
ens
m
icr
ow
av
e ov
ens
m
icr
ow
av
e ov
ens
w
arming draw
er
s
monogram.com
A
dv
antium
®
Speedcook
w
all ov
ens
Cutout and product dimensions
Advantium 240 oven installed alone
Order a 30"-wide single oven cabinet or cut the opening in
a wall to the dimensions shown.
30" 23-1/2"
19"
29-3/4"
25-1/4"
Min.
17-1/2"
36-3/4"
Min.
21-1/2"
Recessed
Depth
Construct
Base
Min. 3/8"
Plywood
Supported
by 2x4 or 2x2
Runners all
Four Sides
Advance planning for wall ovens with Advantium 240
Speedcook technology
Advantium 240 oven installed above a Monogram
warming drawer
An anti-tip block must be installed at the rear of the
warming drawer opening. Again, see installation
instructions for complete details.
• The warming drawer must be supplied with a separate
120V, 60Hz, properly grounded receptacle.
Advantium 240 oven installed above a Monogram single wall
oven and a warming drawer
An anti-tip block must be installed at the rear of the warming
drawer opening. See installation instructions for complete details.
• The Advantium oven and single oven combination must use
separate electrical junction boxes.
• The warming drawer must be supplied with a separate
120V, 60Hz, properly grounded receptacle.
Note: Additional
clearance between
cutouts may be
required. Check to be
sure the oven supports
above the warming
drawer location do not
obstruct the required
interior 23-1/2" depth
and 9-1/4" height. See
each specific product’s
installation instructions
for details.
30" 23-1/2"
17-1/2"
45-1/4"
Min.
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min.
Per Oven
Requirement
2" Min.
Per warming drawer requirement
25-1/4"
36-3/4" Min.
530Dia13
30"
23-1/2" Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners all
Four Sides
2" Min.
Per Warming
Drawer
Requirement
25-1/4"
17-1/2"
Advantium 240 oven installed above a Monogram single
wall oven
When installed over a single oven or a warming drawer, allow at
least 2" between the two openings. This separation will provide
clearance for bottom overlap of the Advantium oven and top
overlap of the single oven or warming drawer.
• The Advantium oven and single oven combination must use
separate electrical junction boxes.
The Monogram ® Advantium built-in oven can be installed directly
into a wall or 30"-wide wall oven cabinetry. Install it alone, with a
single oven or with a warming drawer. Create a complete
cooking center by installing the Advantium with both.
• This oven must be installed at least 36-3/4" above the floor.
• For personal safety, this oven cannot be installed in a cabinet
arrangement such as an island or peninsula.
• This oven is not approved for installation below a countertop,
side by side or stacked.
Electrical requirements
Product rating is 208/240V, 60Hz, 30 amps. This product must be
connected to a supply circuit of the proper voltage and frequency
and protected by a time-delay fuse or circuit breaker.
Note:
Additional
clearance
between
cutouts
may be
required.
Installation note:
The Advantium 240 ovens now have the same cutout
dimensions as the 120 Advantium. If replacing an older
Advantium 240 oven (ZSC2001F or ZSC2001C), choose the new
integrated ZSC2201NSS and the matching storage drawer,
ZX2201NSS. Installed together, they fit perfectly into the old
Advantium 240 cutout. See combined Advantium and accessory
cutout dimensions on the next page.
30" 23-1/2"
36-3/4" Min.
45-1/4"
Recommended
Construct Solid
Bottom Min. 3/8"
Plywood
Supported by
2 x 4 or 2 x 2
Runners, all
Four Sides
2" Min.
Per Oven
Requirement
17-1/2"
25-1/4"
* The middle rail
separating the
two openings
may need to be
larger than the
2" min. shown.