GE ZDP364NDPSS - Manual (Page 21)

TOOLS YOU NEEDED FOR CONVERSION
2 CONVERT THE REGULATOR
Disconnect all electrical power at the main circuit
breaker or fuse box.
A. Remove the rear vent
trim (on ranges only) to
access the regulator.
The Rangetop regulator
is on the left bottom
corner.
B. Shut off the gas supply
by closing the manual shut-off valve in the unit or at the
wall.
C. Convert the pressure regulator:
• Unscrew the cap with plunger.
• Place your thumb against flat side of the plunger and
press down to snap the plunger out of the cap.
• Carefully look at the plunger to locate the NAT or LP
position.
• Turn the
plunger over
so that the
desired gas is
showing near
the bottom.
• Snap the
plunger back into the cap.
• Screw the cap back onto the regulator.
3 CHANGE BURNER ORIFICES
INSTALLATION TIP: First remove all
orifices and then start replacing them.
This will help to prevent the possibility
that some may not be replaced.
A. Remove the burner grates,
burner caps and burner heads.
B. Loosen the top burner
orifices using a 7 mm
nut driver. Use small
pliers to carefully lift out the orifices.
The main orifice is located low in
the center of the
burner, while the
simmer orifice is
located higher
beside the center
of the burner.
DOWN FOR OFF
NAT
LP
LP
NAT
LP
NAT
NAT
LP
Gasket Cap
Plunger
LP Position NAT. Position
Pressure Regulator
Main
Orifice
Simmer
Orifice
WARNING:
This conversion must be
performed by a qualified installer or gas supplier in
accordance with the manufacturer’s instructions
and all codes and requirements of the authority
having jurisdiction. Failure to follow instructions
could result in serious injury or property damage.
The qualified agency performing this work assumes
responsibility for the conversion.
WARNING:
The rangetop, as shipped
from the factory, is set for use with its intended
gas. If you wish to use your rangetop with the
alternate gas, you must first replace the orifices
and convert the pressure regulator.
WARNING:
The following adjustments
must be made before turning on the burner.
Failure to do so could result in serious injury. Be
sure pressure regulator has been converted as
described in Step 2.
Safety Glasses
Small Flat-Head Screwdriver
(2 to 2.4 mm or 3/32” tip size,
60 mm long)
Crescent Wrench
1/4” and 7mm
Nutdrivers
Installation
Convert Natural Gas to LP Gas Operation
Instructions
Convert LP Gas to Natural Gas Operation
Small Pliers 1/2” Deepwell
Socket Wrench
Philips
Screwdriver
ORIFICE HOLDER
The range orifice holder
is located behind the front
access panel at the bottom
of the range.
The rangetop orifice holder
is located inside the range
insulation cover.
Additional orifices may be present. Use only the orifices
specified in the instructions for your range or rangetop.
Burner Cap
Burner
Head
Spark
Igniter
Burner Base
21
Griddle
Orifice
Grill
Orifice
Burner Orifices
1
Range Regulator