GE ZE2160SF - Manual (Page 2)

2
CUTOUT DIMENSIONS
* Min. depth with receptacle outside cabinet 19 1 ⁄
2
″
Min. depth with receptacle inside cabinet 22 ″
Installation Instructions
Models 27
″
30
″
Height 16 3 ⁄
4
″
16 3 ⁄
4
″
Width 25 1 ⁄
2
″
25 1 ⁄
2
″
Depth (min.)* 19 1 ⁄
2
″ or 22″
19 1 ⁄
2
″ or 22″
On 27
″ models, allow 1
1 ⁄
4
″ at the top,
9 ⁄
16
″ on the sides
and 1
″ at the bottom for overlap of the Trim Frame
over the edges of the cutout.
On 30
″ models, allow 1
1 ⁄
4
″ at the top, 2
1 ⁄
8
″ on the sides
and 1
″ at the bottom for overlap of the Trim Frame
over the edges of the cutout.
Depth
Height
1 ″ overlap
Width
INSTALL BOTTOM BRACKET
AND BOTTOM DUCT 2
Fit the tab on the bottom bracket into the slot on
the back of the bottom duct, and push down until
the bracket is flush with the bottom of the duct.
Fasten the bottom bracket to the bottom duct by
using two bronze round-head screws.
Disconnect the microwave oven before proceeding
with the installation.
Remove any loose items inside the microwave
oven, including the turntable and turntable
support. Carefully turn the microwave oven
upside down.
Line up the tabs on the bottom duct with the slots
on the bottom of the microwave and insert the
tabs into the slots. Secure the bottom duct with
four bronze round-head screws as shown.
A
C
B
D
Front
Rear
Screws
Screws
Screws
Microwave Oven Upside Down
1
1 1 ⁄ 4
″ overlap
1 ″ Clearance beyond
Trim Frame
(on all sides)
27 ″ Models: 9 ⁄ 16
″ overlap
30 ″ Models: 2 1 ⁄
8
″ overlap
3 ″ min.
CAUTION
This trim kit uses air flow from the top, bottom and
sides of the trim frame. Blocking the air flow can
cause the microwave to function improperly and
may cause damage to the microwave.
Allow a 1
″ clearance beyond the edge of the Trim
Frame to provide proper air flow.