GE ZBD1850NII - Manual (Page 9)

Installation Instructions
Figure I
• Lay the dishwasher on its back. Remove the four screws
securing the toekick to the dishwasher, and remove the
toekick.
• Remove the single screw just above and to the side of each
front leveling leg.
• Remove the side panels and set the dishwasher upright.
To adjust the door springs:
• Pull the spring adjustment pin out of the holes, insert in the
next highest or lowest hole and test again.
Figure J
Figure K
• Adjust both door springs to the same tension.
• Continue moving the spring pin until door is balanced.
• Replace the dishwasher side panels and proceed to Step 2.
7
Screws
Toekick
Screw
Screw
Increase
Decrease