Audiovox PRO 9842 - Manual (Page 5)

Page 5
REMOTE PANIC OPERATION
The left button of your keychain transmitter also serves as a panic switch and will cause
the siren to sound on demand. To use the panic feature, you must be within the system's
maximum operating range. In an emergency situation, to use the panic feature, press and
hold the left button of your keychain transmitter for 3 seconds. This will cause the lights to
flash, the siren to sound. The panic mode will continue for 30 seconds and then reset.
To disengage the panic feature before the 30 seconds are up, press and hold the left
button of your keychain transmitter for 3 seconds.
While the panic mode is engaged, the doors can be remotely locked and unlocked via the
transmitter by pressing the left button momentarily.
ADDITIONAL REMOTE FUNCTION CHANNEL 2
The system has an additional feature, (Channel 2) , that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are:
Remote Trunk Release
Remote Window Close
Remote Garage Door Interface
To operate the accessory associated with Channel 2, press and hold the right button of
your keychain transmitter for three seconds.
NOTE: You may access the Channel 2 command regardless of whether the system is
"armed" or "disarmed", but not when the ignition switch is in the on position. This is to
prevent the output from accidentally opening the vehicle's trunk when the vehicle is in
motion.
IGNITION DOOR LOCKING/UNLOCKING
When connected to a vehicle's power door lock system the PRO 9842 is capable of being
programmed for the added safety and security of ignition controlled door locking and
unlocking. These features are separate, so the PRO 9842 may be programmed for one,
or both, or neither. These features can only be used if the optional door lock/unlock circuit
is installed.
When the ignition door locking feature is programmed, the PRO 9842 system will cause
all door locks to lock whenever the ignition switch is turned from the "off" to "on" position,
(providing that all doors are closed at that time). All doors will lock approximately 2 sec-
onds after the vehicle's ignition switch is turned on. This is a nice feature for maintaining
the personal safety of the occupants of the vehicle, in an effortless and automatic manner.
When the ignition door unlocking feature is programmed, the PRO 9842 system will cause
all door locks to unlock whenever the ignition switch is turned from the "on" to "off" posi-
tion. All doors will unlock immediately after the vehicle's ignition switch is turned off.
As stated these features are programmed separately, so you may chose to use one, both,
or neither. Please consult with your dealer to consider your options.