GE ZIF360NXLH - Manual (Page 17)

17
Anti-Tip Bracket Installation
36” All-Refrigerator and All-Freezer Units
Anti-tip
bracket
installation
(cont.)
Install Wall Toggles:
The wall toggles and bolts can be ordered
as Service Kit #WR49X10193. Wall toggles
are installed in the drywall and metal studs
for stability. Install the wall toggles as follows:
• Drill 1/2" holes at the wall markings made
in the holes at the ends of the wall bracket.
• Hold the metal channel flat against the plastic
straps and slide the channel through the hole.
• Gently pull back at the ends of the plastic
straps to make the channel rest flush behind
the wall.
• Hold the ends of the straps in one hand
and slide the plastic cap along the straps until
the flange of the cap is flush with the wall.
• Place your thumb between the plastic straps
and bend up and down to snap the straps off
at the wall.
Install Screws and Bolts:
• Have someone hold the wall bracket centered
in place with each of the holes aligned with
the correct opening in the bracket and level
with the horizontal line.
• Insert the lag screws through the bracket
and into the stud. Tighten with a wrench.
• Insert the bolts into the toggle by hand until
snug. Tighten with a wrench.
Anti-Tip Wall Bracket
Bolt
Wall Toggle
Drywall or
Steel Stud
Plastic Straps
Metal Channel
Cap
Wood Stud
Lag Screw
Anti-Tip Wall Bracket