GE 97962 GE 19-in-1 Card Reader & 3-Port USB 2.0 Hub - Manual (Page 5)

8. Hardware Installation
1. Plug the included AC power adapter into the Power Jack on your
Card Reader/Hub.
2. Plug the included AC power adapter into a standard electrical outlet
or GE branded Surge Protector.
3. Plug the mini B USB plug of the cable into the card reader.
4. Plug the standard A USB plug of the cable into your computer or
USB hub.
5. Your computer will detect your card reader and hub, and may load
additional drivers for it.
6. The card reader will show up as four removable storage drives on
your computer, one for each card slot. This can be seen in “My
Computer”.
7. Insert your card into the appropriate slot on your card reader
following the guidelines in section 6.
Note:
If the card is not able to be read or you incur an error, you may not have
allowed enough time for all of the additional drivers to load. Remove and
re-insert the card.
9. Technical Support
For technical support, please visit our website:
www.jascoproducts.com