GE 45605 GE Z-Wave Duplex Receptacle - Manual (Page 11)

Shut off power to the circuit at fuse box or circuit breaker.
Remove wall plate.
Warning!: Verify power is OFF to receptacle before continuing.
Remove the receptacle mounting screws.
Remove the receptacle from the box.
Disconnect the wiring from the old receptacle.
Connect the Z-Wave receptacle as shown in the wiring
diagram.
Insert Z-Wave receptacle into outlet box being careful not to
pinch or crush wires.
Secure the receptacle to the box using the supplied screws.
Mount the wall plate.
Reapply power to the circuit at fuse box or circuit breaker and
test the system.
Observe Important Wiring Information
Always follow the recommended wire strip lengths and
wiring combination when making wiring connections.
You may wish to consult a electrician with questions or for
professional installation.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
SHOCK HAZARD!
Turn OFF the power to the branch circuit at the circuit
breaker in your electrical service panel. Ensure power
is OFF before you install this device. All wiring connections
must be made with the POWER OFF to avoid personal
injury and/or damage to the switch.
WARNING