AMX UDM-0102 - Manual (Page 24)

UDM-0102 Wiring and Connections
12 UDM-0102 and UDM-RX02 Operation/Reference Guide
Connecting an IR Device to an IRTX Port
To issue IR commands to the display device such as power on or power off, an IR01 Endeleo IR Emitter
Module (FG-IR01) is needed:
1. Connect the IR Emitter Module cable to the appropriate IRTX port on the UDM-0102.
2. Run the other end of the cable to the display device, and attach the IR Emitter over the device’s IR
sensor by removing the cover on the reverse side of the IR Emitter.
3. The UDM-0102 is now capable of issuing IR commands to the display device.
IR commands for each device on the system have to be learned by the UDM-0102 in order to function
properly. Refer to the Protocols and IR Learning section on page 49 on how to learn a device’s IR
commands.
IR Receiver (IRRX) Port
The IR RX port has two purposes:
It is used for devices utilizing Passthrough Mode. Refer to the Passthrough Mode (Inputs A –
B) section on page 30 for information.
Also used for learning and creating new IR protocols. Refer to the Creating and Learning an
IR Protocol section on page 51 for details.
FIG. 8 IR Transmit/Receive Ports
IRTX1 IR Transmitter port (3.5mm stereo output)
IRTX2 IR Transmitter port (3.5mm stereo output)
IRRX IR Receiver port (3.5mm stereo input)
IR devices controlled via the IRTX ports are typically installed within the same
equipment rack as the UDM.
FIG. 9 IR01 Endeleo IR Emitter Module
Ensure the position of the device corresponds to the position assigned in the Devices
option of the UDM-0102’s WebConsole.