AMX UDM-0102 - Manual (Page 30)

UDM-RX02 Wiring and Connections
18 UDM-0102 and UDM-RX02 Operation/Reference Guide
Connecting a Component Video Input
1. Attach the Component cables (normally green, blue and red) to the Y (green), Pb (blue) and Pr
(red) connectors on the UDM-RX02 (see FIG. 12 on page 15).
2. Run the other end of the Component cable to the Component connectors (normally green, blue and
red) on the display device. Connect firmly.
3. If appropriate connect audio to the audio connectors on the UDM-RX02.
Connecting the UDM-RX02 Receiver to the UDM-0102 Hub
The RJ45 port on the front panel of the UDM-0102 Hub labelled “UDM” supports one UDM-RX02
Receiver. The UDM-RX02 is then be connected to a display device (FIG. 15).
1. Connect a standard Cat5/6 Ethernet cable to the RJ45 port labelled UDM on the front panel of the
UDM hub.
2. Connect the other end of the Ethernet cable to the RJ45 port labelled UDM Hub on the rear panel of
the UDM-RX02.
UDM HUB Port LEDs
2 LEDs are visible at the UDM Hub port (on the UDM-RX02) when the UDM-0102 is switched on:
Green – Connection to UDM-0102 (if Cat 5 removed, LED switches off)
Amber – Power (as well as comms if uploading protocols etc. the Amber LED may flicker)
FIG. 15 UDM-0102 - front panel
Ethernet cable
Ensure the port the UDM-RX02 is attached to is configured correctly within the Status
option of the WebConsole (for example, if a UDM-RX02 is connected to the Hub,
ensure the port in the Status option is configured likewise.