AMX UDM-0102 - Manual (Page 33)

Configuration
21 UDM-0102 and UDM-RX02 Operation/Reference Guide
Configuration
WebConsole Overview
Each UDM-0102 Hub can be configured for the correct network environment. It is also possible to
configure each Hub for the correct date and time. Configuration options are available via the UDM Hubs
built-in WebConsole, as described in this section.
The UDM-RX02 receiver connected to the UDM-0102 is also configured via the Hub’s WebConsole.
Connecting to the UDM-0102
1. With the TCP/IP address configured, connect the UDM-0102 to your network equipment (switch,
hub, or serial port) - or if required use an Ethernet Crossover cable to connect your PC directly.
2. Enter the IP address into the address field within a browser window.
3. To connect to the UDM-0102, a password is required (FIG. 17).
The username should be left blank.
The password is admin.
This section describes the pages that comprise the UDM-0102’s WebConsole
interface in the order that they are presented (“Status”, “Setup”, “Schedule” and
“Protocol”). However, on initial connection, you’ll probably need to visit the Setup
page first, to specify network configuration and other basic device setup options for
the Hub.
See the Setup Page section on page 36 for details.
The default IP address of the UDM-0102 is 192.168.0.96.
FIG. 17 UDM-0102 Login screen
The password is case sensitive.