AMX UDM-0102 - Manual (Page 38)

Configuration
26 UDM-0102 and UDM-RX02 Operation/Reference Guide
Issuing Commands To a Selected Port
1. Select the Control option from the available options at the top of the Status page.
2. Click the down arrow on the Control drop-down menu to access a listing of supported commands
(FIG. 27).
3. Select the required control.
The command is sent as soon as it is selected.
The Execute button re-sends the selected command.
Ensure the device’s IR commands have been learned by the Hub first. Refer to the
Protocols and IR Learning section on page 49 for details.
FIG. 27 Control drop-down menu
Execute button
Where a custom control is required, type in the IR code for the command. Refer to
the Appendix B – Endeleo IR Codes section on page 67.
Ensure that an IR01 IR Emitter Module is connected to the UDM-RX02’s IRTX port.
Attach it to the device’s IR sensor before issuing a command. This IR Emitter Module
is used to transmit the command from the UDM-RX02 to the device’s IR sensor