AMX UDM-0102 - Manual (Page 46)

Configuration
34 UDM-0102 and UDM-RX02 Operation/Reference Guide
Compensating Video Via the UDM-RC10 Remote Control
Video can also be compensated using the Endeleo UDM-RC10 IR Engineering Remote Control
(FIG. 39).
1. Ensure the IR03 Endeleo External IR Receiver Module (FG-IR03) is attached to the UDM-RX02 at
the IRRX port (FIG. 39).
2. To enter compensation mode, push button A then button B on the remote control.
3. The amber LED at the Cat5 port on the UDM-RX02 will start to flash, indicating the UDM-RX02 is
in compensation mode.
4. Use the buttons on the remote control to adjust appropriately the following up or down;
Sharpness
Gain
Red, Green and Blue.
5. Once the image displayed is of an acceptable quality, push the Esc button on the remote control to
exit compensation mode.
Video compensation settings can also be configured via hyper terminal session. See
the Advanced Administration section on page 57 for details.
FIG. 39 UDM-RX02 with IR03 IR Receiver Module
IR RX port
UDM-RX02
Amber LED indicates that UDM-RX02 is in Compensation mode
IR03 IR Receiver Module (FG-IR03)
The compensation settings will be specific to this UDM-RX02 and stored internally
(for example, if this UDM-RX02 is replaced or swapped out the compensation
settings will travel with the UDM-RX02). It may therefore be necessary to re-
compensate the UDM-RX02 / replacement UDM-RX02 if this UDM-RX02 is to be
used elsewhere or is being replaced.