AMX UDM-0102 - Manual (Page 49)

Configuration
37 UDM-0102 and UDM-RX02 Operation/Reference Guide
Adding Centrally Located Devices
1. Select Devices from the options at the top of the Status page to access the Device Configuration
options (FIG. 43).
2. Name the device accordingly by typing in the Name text field.
3. Configure the device with the relevant IR protocol if appropriate.
Refer to the Creating and Learning an IR Protocol section on page 51 for details.
4. Configure the device with the correct Associated Input (for example, where the device, as an Input
type, is physically cabled to on the Hub).
If the device is connected to an input at the rear of the Hub select the relevant associated input
(A-B).
Device Configuration and Control
The system allows centrally located devices connected to the rear of the UDM-0102 (e.g. VCR, DVD,
DVR or Satellite Decoders) to be managed from the user port. This is performed through the Devices
page.
Custom Controls
Custom Controls permit the Administrator to specify custom IR controls which can be sent to the device
or display.
FIG. 43 Device Configuration options
Ensure the correct port is selected.
FIG. 44 UDM-0102 - IRTX and IRRX ports
IRRX port
IRTX ports
Note that commands listed in the Actions drop-down menu do not require custom
code. See the Appendix B – Endeleo IR Codes section on page 67.