AMX UDM-0102 - Manual (Page 59)

Configuration
47 UDM-0102 and UDM-RX02 Operation/Reference Guide
6. If an interval is required between each individual schedule within the Preset schedule, specify a time
interval (in minutes) in the Interval field (FIG. 65).
7. Click Add to save this Preset to the Hub. The new event information is displayed as shown in
FIG. 63:
8. Click on the checkbox shown in FIG. 66 to enable this scheduled event for use. Each scheduled
event must be enabled before it can be used.
Protocols Page
Click the Protocols link on the left side of the WebConsole to invoke the main Protocols page (FIG. 67).
Use the options on this page to create protocols for serial and IR devices used in the system. These
protocols will allow the UDM-0102 to control serial and IR devices connected via the Hub.
FIG. 66 Displayed Scheduled Event and Presets
Click here to enable this
Preset for use
These numbers indicate the scheduled events
in this Preset, and the ore in which they will
occur (based on the numbers assigned to each
scheduled event)
No checkbox appears to the left of the combined event as several combined events
can not be added together.
FIG. 67 Protocols Page