Garmin GPSMAP 60Cx - Manual (Page 12)

Installing the Batteries
The GPSMAP 60Cx operates on two AA batteries
(not included), which are installed in the back of the
unit. You can use Alkaline or NiMH batteries. See
page 55 for information on setting the battery type.
To install the batteries:
1. Remove the battery cover
by turning the D-Ring 1/4
turn counter-clockwise and
pulling the cover loose.
2. Insert the batteries,
observing the proper
polarity. A polarity diagram
is molded into the battery
compartment.
3. Reinstall the battery cover
by aligning the back cover
with the unit and turning the
D-Ring 1/4 turn clockwise.
Remove the batteries from your GPSMAP 60Cx when
you do not expect to use the unit for several months.
Stored data is not lost when batteries are removed.
Note: Lithium batteries are not recommended
because the initial voltage of new batteries may
exceed 1.5 volts each, which may cause the
GPSMAP 60Cx to turn off.
To install the Lanyard:
1. Place the loop of the lanyard through the slot
at the upper-left side on the back of the unit.
2 Route the strap through the loop, and pull tight.
Wrist Strap
Installation
Refer to page 9 for information on accessing the
microSD ™ data card in the battery compartment.
USE BY
2009
USE BY
2009
Battery
Compartment
USE BY
2009
USE BY
2009
Battery
Compartment
GPSMAP 60Cx Owner’s Manual
g
ettIng
s
tArted
> I
nstAllIng the
b
AtterIes