Brewer Element Treatment 2110 - Manual (Page 2)

Document 101291 RevA Printed in USA © 2010 2
MODEL 2110
For the above model you will receive
two separate cartons: a frame carton,
and an upholstery carton. Inspect both
carefully for shipping incurred damage.
1/4”-20 x 3” Screw A (Qty. 2)
1/4”-20 x 1 1/4” Screw C (Qty. 8)
1/4”-20 x 1” Screw F (Qty. 4)
J-Bolt R (Qty. 2)
Allen Wrench (Qty. 1)
Snap Rivet (Qty. 26)
3/8” Nut L (Qty. 2)
Washer M (Qty. 2)
CAUTION
To avoid damaging the table’s upholstery or
painted surfaces, DO NOT use a knife or any other
sharp object to open the packaging.
WARNING
Two or more people should assist in moving the table.
Use proper lifting techniques when lifting. Failure to
do so could result in serious injury!
1/4”-20 x 2” Screw B (Qty. 4)
9/16” Open End Wrench
Phillips Screw Driver
COMPONENT IDENTIFICATION
Perform the following sequence in order when setting up
the table:
- Unpacking
- Assembly
- Leveling the Table
- Installing the Paper Roll
NOTE: Inspect all boxes and contents for damage.
Report any damage to the carrier immediately.
OVERVIEW
COMPONENT IDENTIFICATION
MODEL 2110 HARDWARE
NOTE: Save all packaging in case re-shipment is re-
quired.
MODEL 2110 TOOLS NEEDED