Brewer Element Treatment 2210 - Manual (Page 2)

Document 101293 RevA Printed in USA © 2010 2
1/4”-20 x 3” Screw A (Qty. 2)
1/4”-20 x 1 1/4” Screw C (Qty. 8)
1/4”-20 x 1” Screw F (Qty. 4)
J-Bolt R (Qty. 2)
Allen Wrench (Qty. 1)
Snap Rivet (Qty. 32)
3/8” Nut L (Qty. 2) Washer M (Qty. 2)
CAUTION
To avoid damaging the table’s upholstery or
painted surfaces, DO NOT use a knife or any other
sharp object to open the packaging.
WARNING
Two or more people should assist in moving the table.
Use proper lifting techniques when lifting. Failure to
do so could result in serious injury!
1/4”-20 x 2” Screw B (Qty. 8) 8-32 x 1 1/4” Screw E (Qty. 8)
8-32 Nut K (Qty. 8) 1/4”-20 x 1/2” Screw G (Qty 1)
1/4”-20 Nut H (Qty 1)
MODEL 2210
9/16” Open End Wrench
11/32” Socket or Wrench
Phillips Screw Driver
For the above model you will receive
three separate cartons: a frame & shelf
carton, an upholstery carton, and a
drawer carton. Inspect all three carefully
for shipping incurred damage.
COMPONENT IDENTIFICATION
Perform the following sequence in order when setting up
the table:
- Unpacking
- Assembly
- Leveling the Table
- Installing the Paper Roll
NOTE: Inspect all boxes and contents for damage.
Report any damage to the carrier immediately.
OVERVIEW
COMPONENT IDENTIFICATION MODEL 2210 HARDWARE
NOTE: Save all packaging in case re-shipment is re-
quired.
MODEL 2210 TOOLS NEEDED