Autostart Keyless Entry And Alarm System ASL-500 - Manual (Page 5)

User Guide P. 5
Features Available on your System
Relock doors
If you unlock the doors with the remote transmitter, but do not open any door or open trunk within 60 seconds,
the doors will automatically relock and the system will be armed.
Note: When the system is in active arming mode and the relock mode is enabled, the doors will relock but the
system will not rearm.
Panic Mode
In a panic situation, you can activate the panic mode that disables the valet mode, locks the doors and sounds
the siren for 1 minute. You can activate the panic mode by pressing the LOCK or the UNLOCK button for
approximately 4 seconds until the siren goes ON and the parking lights flash.
To activate panic mode:
• Press and hold the UNLOCK button for approximately 3 sec. until the sound signal starts and the
parking lights flash: this will unlock the doors before the sound signal starts.
• Press and hold the LOCK button for approximately 3 seconds until the sound signal starts and the
parking lights flash: this will lock the doors before the sound signal starts.
Or
•
Press and hold the FUNCTION button for approximately 3 sec. until the sound signal starts and the
parking lights flash: this will only activate the siren.
(For two-way LCD remote only)
Multi-car Operation
The system features multi-car operation. This allows the user to control two systems with one transmitter. (Both vehicles must
be equipped with identical systems). The transmitter of the primary vehicle can control the starter kill system, the door lock and
unlock operations of the second vehicle as well as the AUX 2 and AUX 3 outputs. The transmitter of the second vehicle can
also operate the primary vehicle
For 1-WAY remote:
• + .....................................................Lock
• + ................................................Unlock
• + . ...............................................Aux 2
• + + . ......................................Aux 3
For 2-WAY LCD remote:
• Press and hold the FUNCTION button until you hear a “beep”. Within 3 seconds, release the
FUNCTION button and will appear on the LCD display. Press and hold the FUNCTION
button once more until you hear another “beep”. will be displayed. This display
means that you are now in Multi-car Operation Mode. Simply press the corresponding
button to access the desired feature:
• ..............................................................Lock
• ...............................................................Unlock
• . ..............................................................Aux 2
• . ..............................................................Aux 3
Temporary Chirp Delete
If you want to avoid the siren chirps in a quiet neighbourhood when arming or disarming the system, press the
TRUNK button until you see the parking lights flash. Then within 3 seconds, press the LOCK or UNLOCK to arm
or disarm the vehicle without generating the siren chirps.
Note:
Your installer could program the chirp disable feature, so that the chirps are disabled permanently.