STEINEL GF 3002 - Manual (Page 4)

Declaration of conformity
This product complies with
Directive 06/95/EC on low- voltage appliances and
EMC Directive 04/108/EC.
Functional Warranty
This STEINEL product has
been manufactured with
utmost care, tested for
proper operation and safety
and then subjected to ran-
dom sample inspection.
STEINEL guarantees that
it is in perfect condition and
proper working order.
The warranty period is
36 months, starting on the
date of sale to the con-
sumer. We will remedy de-
fects caused by material
flaws or manufacturing
faults. The guarantee will be met
by repair or replacement of
defective parts at our own
discretion.
If the power lead on this
equipment is damaged, it
should only be replaced by
a repair workshop autho-
rized by the manufacturer.
The warranty shall not cover
damage to wear parts,
damage or defects caused
by improper treatment or
maintenance. Further con-
sequential damage to other
objects shall be excluded.
Claims under the warranty
shall only be accepted if the
product is sent fully assem-
bled and well packed com-
plete with a brief descrip-
tion of the fault, a receipt or
invoice (date of purchase
and dealer's stamp) to the
appropriate Service Centre. Repair Service:
Our Customer Service
Department will repair faults
not covered by warranty or
after the warranty period.
Please send the product
well packed to your nearest
Service Centre.
6 7
Laying telephone cable.
Operating Gluematic 3002
Operating Gluefix
Decorating glass.
Sealing parcels the secure
way. Hot-melt adhesive for
model making.
Decorating wood. Finishing edges.
GB
Gluematic 3002 Gluefix
Supply voltage: 100 – 240 V 100 – 240 V
(variable without a change-over) (variable without a change-over)
Output: Heating-up mode 200 W, Heating-up mode 175 W,
standby mode approx. 16 W, standby mode approx. 16 W,
working mode approx. 45 W working mode approx. 40 W
Heating-up time: approx. 7 minutes 7 – 8 minutes
Diameter
hot-melt adhesive:
11 mm 11 mm
Melting temperature: 206° C 200° C
Cartridges: original STEINEL and original STEINEL and
Henkel cartridges Henkel cartridges
Technical specifications are subject to change without notice.
Technical specifications
glue stick, wait a mo-
ment for the cold car-
tridge to heat up. Never
force the glue stick
through the applicator!
í Using excessive pres-
sure can cause the glue
stick to jam in the glue
gun and block the trig-
ger. In such a case, heat
the glue gun for approx.
10 minutes and then
pull the glue stick out
3 – 5 mm. If the glue
stick is too far inside the
glue gun, heat a new
stick at the nozzle, bond
it to the jammed stick
and then withdraw it with
gentle pressure.
í Do not pull the
glue stick out of
the applicator complete-
ly. Hot glue running into
the applicator may cause
damage.
í Gluematic 3002:
Always screw the nozzle
tight after replacing it
(approx. 1 Nm).
í Troublefree operation
can only be guaranteed
when using original
STEINEL and/or Henkel
glue sticks.
í Repairs may only be
carried out by a qualified
electrician.
í Keep out of reach of
children!
í When using our super-
sticks, the adhesive
joints and glued areas
can be painted or var-
nished over or they can
be remelted.