Apple IEEE1394 - Manual (Page 14)

- 8 -
SOFTWARE INSTALLATION FOR WINDOWS Me
1. Boot-up your computer into Windows Me, making
sure the ‘IEEE 1394 Host Controller’ device driver
has been installed and is available. To check this,
right-click ‘My Computer’, click ‘Properties’ and
then ‘Device Manager’ to open the ‘Device Manager’
window. Refer to the figure shown alongside to see if
the IEEE 1394 Host Controller is installed without
error.
2. Ensure the IEEE 1394 interface cable and then the AC adapter connections are made as described
in Hardware Installation. Insert the port connector of the IEEE 1394 cable into the IEEE 1394 port
of your computer.
3. Windows Me will install its resident device driver automatically. After the installation, you will
find a new drive letter has been assigned for the drive in ‘My Computer’.