American Fibertek MT-946C-SL - Manual (Page 4)

4
POWER CONNECTION
Power is supplied to the unit via a two pin terminal connector on the right side of the unit. Follow the
label on unit for proper orientation of +12 volt dc and ground.
FIBER CONNECTION
The fiber optic connection is made via a ST connector located on the right side of the unit.
VIDEO INPUT CONNECTIONS
The video input connections are made via BNC connectors on the right side of the unit. The video
inputs should be connected to an appropriate 75
 baseband video source such as a camera or a video
recorder output. For optimum performance the video cables should be the shortest length of coax
practical.
DATA INPUT / OUTPUT CONNECTIONS
Data input and output connections are made via the terminal block labeled DATA 1 on the left side of
the unit. See the drawings below for proper orientation of input and output connections. Please note
that the far left pin on each connection drawing corresponds with the far left terminal block pin located
closest to the top of the unit. For example, DATA IN + for RS422 is the pin located closest to the DATA
2 terminal block.
af i
american