American Fibertek N-TAH - Manual (Page 28)

28
Action selects if the target aux output is to be set ON or OFF in response to the local
alarm condition.
Duration sets how long to set the target output for. If a duration is set, the N-TAH will set
the target aux contact out to the selected status (ON or OFF) for the chosen duration,
and them will set the target to the opposite setting. Thus, if an alarm is set to trigger a
certain aux ON for 5 seconds, the N-TAH will when that alarm is triggered contact the
target unit, set the indicated aux to ON, wait five seconds, and then set the indicated aux
to OFF.
Selecting “Follow” for the duration will cause the N-TAH to make the targeted aux
contact out follow the state of the alarm input. If the action selected is ON, the target will
be turned ON whenever the local alarm goes ON, and OFF when the local alarm goes
OFF. Selecting an action of OFF will invert the behavior, causing the targeted aux to go
OFF when the local alarm is triggered and ON when it is not.
Selecting “Indefinitely” for the duration will simply cause the N-TAH to set the target aux
contact ON or OFF once and leave it so set.
Buttons are provided which force an ON or OFF message to be sent to the indicated
remote aux output immediately. These are used to test unit configuration and network
connectivity.