American Fibertek SMH10p-PoE - Manual (Page 123)

114
a certain period (for details, see the IEEE 802.3af specification).
 Capacitive Detection: If the port and capacitive detection are enabled, the
capacitances state reads in the voltage result from the constant current. This is then
subtracted from the pre-capacitance voltage to get a charge rate. If this charge rate
is within the window of the PD signatures, the device is considered to be discovered.
 Start: Showing with a tick symbol, the system initializes and resets successfully.
 And then, click
Apply to carry into effect.
 Port: The index of PoE ports.
 Enable State: Check it to enable the PoE function to the port.
 Power Limit From: Check it to decide the power limit method.
 Classification: When this check box is ticked, the system will limit the power
supply to the powered device in accordance with the related class.
 Legacy: Check it to support the legacy power devices.
 Priority: Pull down the selection menu item to choose the priority of power
supplying.
 Port Limit (<15400) mW: User can key in the power limit value which is under 15.4
Watts.
 Mode: Displays the operating mode of the port.
 Current (mA): Displays the operating current of the port.
 Voltage (V): Displays the operating voltage of the port.
 Power (mW): Displays the power consumption of the port.
 Determined Class: Displays the PD’s class.
 And then, click Apply to carry into effect.