BMR Suspension BK024 User Manual
BMR Suspension For the car
Advertising
REAR SUBFRAME BUSHINGS
BK024
Required Tools:
Hydraulic jack and 2 stands (lift optional but recommended)
Wrenches – 18mm, 21mm
Sockets – 10mm, 13mm, 18mm, 21mm
Pry-bar
Sawzall w/long blade
Installation:
1. Lift vehicle and support with stands under the rocker jack points as shown in Image 1 below.
2. Remove both rear wheels.
3. Using a 15mm socket, remove the driveshaft tunnel brace. See Image 2.
4. Using a 15mm socket, loosen the exhaust clamps at the front of the exhaust.
5. Using a helper, slide the rear muffler mounts off the mounting dowels (Image 3) and then pull the
entire exhaust assembly rearward and out of the car.
Continued
Rear Subframe Bushings
Advertising