BMR Suspension DSL014 - Manual (Page 2)

DRIVESHAFT SAFETY LOOP INSTALLATION (Cont.)
DSL014– 2010 Camaro M6
9. Position the assembly up into place on the transmission and thread the (2) mounting nuts onto the transmission mount studs
to hold the assembly in place. (Image 5)
10. Slide the provided spacers under the cross-member mounts as shown in Image 6 then install the 4 factory bolts into the cross-
member. Tighten the (4) mounting bolts to 42 ft/lbs. Tighten transmission mount nuts to 42 ft/lbs also.
11. Slide the BMR “loop” up and over the driveshaft and line the mounting holes up with the mounting bracket holes.
12. Insert the supplied 3/8” x 1” bolts and nuts into the mounting holes and tighten with (2) 9/16” wrenches. (Image 7)
13. Lower vehicle.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
2