BMR Suspension DSL015 - Manual

DRIVESHAFT SAFETY LOOP INSTALLATION
DSL015– 2010 Camaro Automatic
RECOMMENDED TOOLS:
(2) 9/16” wrenches, (1) 19mm socket
15mm, 19mm socket
3/8” drive ratchet or impact
Hydraulic jack and jack stands or Hydraulic service lift
Drill with 3/8” drill-bit
INSTALLATION:
1. Lift vehicle and support safely under frame rails.
2. Support the transmission using a jack stand or jack.
3. Using a 15mm socket, remove the (2) transmission mount nuts.
4. Using the same socket, remove the (4) transmission cross-member
bolts then remove the cross-member.
5. Position the main BMR mounting
bracket onto the factory cross-member as
shown in Image 1. Make sure that the
BMR bracket sits flush on the top
surface and make sure the holes in the
BMR bracket line up with the holes on
the OE cross-member.
6. Once positioned correctly, clamp or bolt
the bracket into place.
7. Mark the cross-member for drilling using
the 3/8”mounting holes as a guide.
8. Remove the BMR mounting bracket and
drill the two holes into the factory cross-
member as shown in Image 2.
9. Using the supplied 3/8” x 1” bolts,
washers and nuts, bolt the BMR
mounting bracket to the OE
crossmember but do not tighten. Insert
and tighten the provided 14mm bolts and
nuts into the top holes. Tighten to 90 ft/lbs. Now tighten the 3/8” bolts to 45 ft/lbs.
10. Position the assembly up into place on the transmission and
thread the (2) mounting nuts onto the transmission mount studs to
hold the assembly in place. (Image 3)
11. Install the 4 factory bolts into the cross-member and tighten them
to 42 ft/lbs. Tighten transmission mount nuts to 42 ft/lbs as well.
12. Slide the BMR “loop” up and over the driveshaft and line the
mounting holes up with the mounting bracket holes.
13. Insert the supplied 3/8” x 1” bolts and nuts into the mounting
holes and tighten with (2) 9/16” wrenches. (Image 4)
14. Lower vehicle.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to vehicle/person during installation or use of this product.
1