BMR Suspension MM004 - Manual

MM004 – INSTALLATION INSTRUCTIONS
2010-2015 CAMARO V8
TOOLS REQUIRED:
Hydraulic jack and stands
Wrenches and sockets: 15mm, 18mm, 19mm
INSTALLATION:
1. Remove the air box assembly on the motor to allow the
motor to be raised during the installation process.
2. Lift vehicle and support safely with jack stands under
the frame rails.
3. Using an 18mm socket, loosen the nuts on the top of the
factory motor mounts as seen in IMAGE 1 to the right.
4. Using the same socket, loosen the nuts on the bottom of
the factory motor mounts as shown in IMAGE 2 below.
5. Place the jack under the oil pan and lift slightly to
remove the weight of the motor off of the factory frame stands. NOTE: some aftermarket headers may not allow access to the
motor stand bolts. In this case, the header must be removed before the stands can be removed.
6. Using a 15mm socket, loosen the (4) bolts on the motor
mount stands then remove the stands from the motor.
7. Assemble the BMR motor mount as shown in IMAGE
3. Once assembled, bolt the BMR mount to the factory
stand using the supplied 12mm x 80mm bolts. Tighten
the bolt and nut until the bushings just start to bulge.
CONTINUED