BMR Suspension STB017 User Manual
BMR Suspension For the car
Advertising
STB017 INSTALLATION INSTRUCTIONS
2011-PRESENT CAMARO
REQUIRED TOOLS:
1. 3/8” drive ratchet with 13mm socket
2. Torque wrench (optional)
INSTALLATION:
1. Open hood and locate the mounting holes
shown in IMAGE 1.
2. Position the BMR Strut Tower Brace over
these holes and insert the supplied 8mm
bolts and washers.
3. Verify that brace is centered then tighten bolts to 25 ft/lbs.
WWW.BMRSUSPENSION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As
such, buyer assumes all risk of any damage caused to vehicle/person during installation or use of this product.
Advertising
Table of contents