BMR Suspension TCA029 - Manual

1
ADJUSTABLE LOWER CONTROL ARMS
TCA028, TCA029 – 2010-present Camaro, 2008-2009 Pontiac G8
RECOMMENDED TOOLS:
Hydraulic Jack and stands
Wrenches: 15mm, 18mm, 2x-21mm, 5mm Allen wrench
Sockets: 18mm socket, 21mm
INSTALLATION:
1. Lift vehicle and support with stands under the cradle.
2. Remove the rear wheels/tires.
3. On G8’s and 2010-2012 Camaros, remove the nut on the sway bar end links as shown in Image 1. Use a
15mm wrench and a 5mm Allen wrench. On 2013-newer Camaros with the FE4 suspension, remove the
end link using a 15mm wrench and 15mm socket.
4. Using a 18mm socket and 18mm wrench, remove the outer control arm bolt. (Image 2)
5. Using a 21mm wrench and 21mm socket, remove the shock cross-bolt. (Image 3)
6. Using (2) 21mm wrenches, remove the inner bolt. (Image 5)
7. Remove OE control arm. NOTE: while it is possible to remove the control arm at this point, it is
somewhat easier to loosen the (4) upper shock mounts. This allows the shock tension to be released and
the control arm comes out much easier.