BMR Suspension CCK001 User Manual
BMR Suspension For the car
COIL-OVER CONVERSION KIT INSTALLATION
CCK001 – 1967-1969 Camaro, Firebird, 1968-1974 Nova
NOTE: This installation can be performed with the engine in the car
however the install is much easier if the inner fenders have been
removed. For illustrative purposes the following installation was
partially performed on a bare subframe.
NOTE: Do not use bushing-type coil-overs with this setup, use only
bearing-type coil-overs.
INSTALLATION:
1. Safely support the vehicle. Remove the upper and lower A-
arms and remaining front suspension to gain access to the
upper A-arm mount.
2. Using an angle-grinder or die grinder with a cut-off wheel,
remove the upper shock mount as shown in IMAGE 1 and 2.
3. Smooth the remaining weld and contour the upper A-arm
bracket using a sanding disc. The frame should appear
similar to IMAGE 3 when finished.
4. As shown in IMAGE 3, lay the drill template into the spring pocket and weld in place with 2-3 tack welds.
1