BMR Suspension TCK005 - Manual

TRANSMISSION CONVERSION CROSSMEMBER
TCC005, TCC030 – 1967-1969 F-BODY
NOTE: This installation covers only the kit components. Aftermarket shifters, clutch master cylinders and/or
pedal assemblies may also be required for this installation and are not covered in this instruction sheet.
INSTALLATION:
1. Lift vehicle and support safely with stands.
2. To proceed, the original transmission and crossmember should be removed and the new transmission
supported in the approximate location. See IMAGE 1 below.
3. Install the supplied polyurethane transmission mount to the transmission using the OE mounting bolts. See
IMAGE 2 below.
4. Install the BMR frame brackets as shown in IMAGE 3 below using the OE mounting holes in the factory
subframe. Use the provided 3/8” x 1” bolts, nuts, and washers, placing a washer on both the top and bottom
of the mounting bolts. Do not fully tighten the mounting bolts at this time but tighten them just enough to
still allow adjustment. After installing both brackets, the setup should look similar to IMAGE 4 below.
5. For 6 speed manual transmissions (T56, Magnum, TR6060) use the provided spacer shown in IMAGE 5 on
the next page. For all other transmissions this spacer is not necessary.
CONTINUED