BMR Suspension TAS006 - Manual (Page 7)

7
31. At this point it is necessary to assemble the coil-over shocks. Using Image 16 as a guide,
thread the lower adjuster onto the shock body and continue threading until it is all the
way to the bottom. Place a spring over the
shock and then insert the upper spring
mount on top of the spring and over the
shock shaft. Insert the spring clip. Thread
the lower shock adjuster up until the
spring has no more slack and seats
squarely on the upper and lower mounts.
32. Slide the upper mount of the shock into
the BMR cross-member making sure the
shock adjustment knobs are facing inward.
Insert the supplied ½” x 2.5” bolt. Repeat
for the other side. Thread a stainless
washer and nut onto the bolt and tighten to 80 ft/lbs Repeat for the other side.
33. Assemble the bottom shock mount as shown in
Image 16b using the provided 5/8” x 4” bolt.
Place a 5/8” small diameter washer on either side
of the poly bushings. Insert the bolt into one of
the middle shock mounts located on the control
arm mount. NOTE: it may be necessary to raise
or lower the rear end in order to insert the bolt.
(Image 17)
34. Place a large diameter washer over the 5/8” bolt
inside the control arm mount and then thread a nut
onto the bolt. Tighten to 80 ft/lbs.
35. Repeat steps 29-31 for the other side.