BMR Suspension RS001 User Manual
BMR Suspension For the car
Advertising
POLISHED RADIATOR COVER
Part # RS001
Tools required:
10mm wrench
3/16” allen wrench
Installation:
1. Using a 10mm wrench, remove the three bolts holding the factory shroud in place and
remove the shroud.
2. Remove the rubber radiator isolators from the existing shroud and place into the BMR
shroud.
3. Install the BMR shroud using the provided stainless hardware and spacers. Spacers go
underneath the outside boltholes.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As
such, buyer assumes all risk of any damage caused to the vehicle/person during installation or use of this product.
Advertising
Table of contents