BMR Suspension CAB003 User Manual
BMR Suspension For the car
G-BODY CONTROL ARM RELOCATION BRACKETS
CAB003 – 1978-1987 G-BODY
NOTE: While this product can be bolted into place, welding is recommended for Drag strip-only cars or vehicles running 60 ft/times
of 1.50 or lower.
RECOMMENDED TOOLS:
(2)
¾”
wrenches
Hydraulic
jack
(2)
9/16”
wrenches
Jack
stands
(2)
18mm
wrenches
MIG
Welder
(optional)
Angle
finder
Drill
with
3/8”
drill
bit
INSTALLATION:
1. Lift vehicle and support with stands under the frame rails.
2. Position the hydraulic jack under the differential and lift the rear-end until the control arms are level. Use an angle finder on
the bottom of the control arm to confirm. (Image 1)
3. Remove both rear wheels/tires.
4. Beginning with one side the vehicle, remove the rear control arm bolt using the 18mm wrenches. (Image 2)
5. Loosen the front bolt and lower the control arm out of the work area.
6. Position the BMR Relocation Bracket over the control arm mount. Insert the supplied spacer inside the mount then insert the
provided 12mm bolt into the top hole and through the factory hole in the rear end (See Image 3). Thread a nut onto the bolt
and tighten slightly, leaving it loose enough to allow rotation of the bracket by hand.
1