BMR Suspension KM011 - Manual

Please take a moment to verify contents of this package before proceeding with the installation. It is the sole responsibility of the
Purchaser to inventory these contents before vehicle disassembly. BMR Suspension will not be held responsible for additional
labor time, service lift charges, etc. that may occur due to missing items.
TUBULAR K-MEMBER INSTALLATION INSTRUCTIONS – 2005-2010 MUSTANG
Part #’s KM009, KM010, KM011
INSTALLATION:
1. Lift vehicle and support with stands positioned under the frame rails. Remove both front wheels/tires.
2. Using a 18mm deep socket, loosen both outer tie rod ends. Knock both tie rods loose from the spindles.
3. Remove the power steering line retainer located in the center of the rack.
This requires a 8mm wrench. See Image1.
4. Using a 18mm socket, remove both rack mounting bolts. Mark a line on
the steering shaft at the front connection point to insure proper re-assembly
location. Remove the front steering shaft bolt using a 13mm socket or
wrench (See Image 2). Leave both power steering lines attached but move
the rack out of the way to gain access to the front A-arm bolts.
5. Remove all 4 rear A-arm bolts using a 21mm deep socket. Using a 18mm
socket, remove both front A-arm bolts.
6. Loosen and remove the A-arms’ ball joint cross-bolts using a 15mm wrench and a 18mm socket. Knock or pry
the ball joint loose from the spindle. NOTE: It is not possible to remove the A-arms until the K-member is
lowered.
7. Using a 15mm socket with an extra long extension, remove both motor
mount nuts from the top.
8. Support the motor from below with a block of wood on a hydraulic jack.
Lift motor slightly.
9. Using a 18mm socket, remove all 8 K-member bolts and lower the
K-member/A-arm assembly.
10. Insert one of the polyurethane motor mount bushings and sleeve into both motor mounts stands on the K-
member and lift the K-member up into place. Insert all 8 mounting bolts but do not tighten.