BMR Suspension SB022 - Manual

HD SWAYBARS – 2005+ MUSTANG
Part # SB022 and SB023
Thank you for purchasing BMR products. Please take a moment to verify contents of this package before proceeding with the
installation. It is the sole responsibility of the Purchaser to inventory these contents before vehicle disassembly. BMR will not be held
responsible for additional labor time, service lift charges, etc. that may occur due to missing items.
Parts List:
SB022 Front swaybar
SB023 Rear swaybar
Hardware – see Image to right
Rear Installation:
1. Lift the rear of the car by
its axle and support. It is
easiest to remove and
install the swaybar with
stands under the axle and
wheels removed.
2. Remove the four outer
swaybar bolts (two on
each side) using a 15mm
socket. Remove the
bushing saddles.
3. Using the same socket,
remove the two (one on
each side) swaybar link
bolts located on the frame
and then remove the
swaybar.
4. Install the bushing end of
the BMR supplied
endlinks into the frame
mounts and install the
factory bolts.
5. Install the 7/8” saddle bushings over the swaybar at the endlink position. Insert the supplied 3/8” bolts, nuts, and washers onto the hanging
endlinks to support the swaybar. Leave these bolts finger tight.
6. Install the remaining 7/8” bushings on the ends of the swaybar and then pivot the bar up into position on the rearend. Insert OE bolts and
tighten.
7. Tighten all endlink bolts. Grease bushings. Re-install wheels and tires and lower vehicle.
Front Installation:
1. Lift nose of vehicle and support with stands.
2. Remove the outer swaybar endlink bolts using a 18mm socket. Leave endlinks attached to struts.
3. Using a 15mm socket, remove all 4 bushing saddle bolts (two per side) and then remove the swaybar.
4. Lube the inside of the 1-3/8” bushings and install them onto the new swaybar.
5. Position the factory saddles over the new bushings and mount the swaybar in place using the OE hardware. Tighten.
6. Pivot the swaybar up into position and insert the endlinks into the swaybar. Tighten.
7. Lower vehicle.
WWW.BMRFABRICATION.COM
This product is an aftermarket accessory and not designed by the vehicles manufacturer for use on this vehicle. As such, buyer assumes all risk of
any damage caused to the vehicle/person during installation or use of this product.