BMR Suspension SB042 - Manual

1
SB042 INSTALLATION INSTRUCTIONS
REQUIRED TOOLS:
Jack and jack stands
13mm, 15mm, 18mm, 19mm, 9/16”, ¾” sockets and wrenches
5/16” Allen wrench
Pry bar
INSTALLATION:
1. Lift vehicle and safely support with stands
under the frame. It may also help the
installation to position the jack under the rear
end and lift it slightly to remove some of the
load off the control arm bolts.
2. If working on jack stands, remove both rear
wheels/tires to gain better access to the work
area. NOTE: the installation pictured was done
on a 2-post service lift and the wheels/tires
were left installed throughout the installation
process.
3. Using a 13mm socket, un-bolt the outer sway
bar mounting bushings as shown in IMAGE 1.
4. Using a 15mm socket, un-bolt the sway bar
end links as shown in IMAGE 2.
5. Remove the factory sway bar.
6. Starting with the drivers’ side of the car,
remove the control arm bolt at the axle using
an 18mm wrench or socket.
7. Directly above the control arm bolt is the axle
damper weight that must also be removed for this installation. Remove it using a 15mm
socket or wrench as shown in IMAGE 3.