BMR Suspension BK005 - Manual

Rear Upper Control Arm Bushing
BK005
Required Tools:
• Hydraulic jack and 2 stands (lift optional but recommended)
• Wrenches – 18mm, 21mm
• Sockets – 10mm, 13mm, 18mm, 21mm
• Pry-bar
Installation:
1. Lift vehicle and support with stands
under the rocker jack points shown
in Image 1.
2. Remove both rear wheels.
3. Using a 15mm socket, remove the driveshaft tunnel brace. See Image 2.
4. Unplug the rear O2 sensors as shown
in Image 3.
5. Using a 13mm socket, remove the
two bolts that hold the rear two
muffler brackets in place. Remove 4
bolts total, 2 per side. See Image 4.
1